To determine the parallel and series
resonance of the Quartz filter we need
to zoom in. You can do this by clicking
into the chart on the top left corner of
the intended zoom area, keep the mouse
button pressed and pull it to the lower
right corner of the intended zoom area as
shown.
In the zoomed window you will see that you are not having enough frequency points. By pressing
you can set the start and stop frequency of the measurement to
match the zoomed window. Right Click into the chart and select Optimize. Repeat these steps until
you achieve a chart as shown in 8-8 on page 56
Figure 8-8: Optimizing the frequency resolution with Get from zoom
For more information on the zoom functions and optimizing check out 11.2.2 Zooming the
measurement curve on page 119 and 7.3 Chart context menu on page 30.
56
OMICRON Lab
To Next Page
Loading...
