Shaped level
The shaped level feature of Bode 100 allows changing the output level over frequency.
To use the shaped level feature, click on the slider selector to switch between constant and variable
level .
After switching to variable, the Output level text field changes its name to Reference level and the
Shape level button appears: .
Click on the Shape level button to enter the shaped level dialog shown in the figure below:
Figure 9-6: Shaped level dialog
In the shaped level dialog you can perform the following actions:
1. Interactive shaped level diagram
Shows the shaped level curve. Use your mouse to enter new shaped level points by double-
clicking or right-clicking into the diagram. Shaped level points can be moved by drag-and-drop in
the diagram. The blue line in the diagram shows the reference level line which allows you to shift
the entire shaped level curve up and down.
2. Shaped level points table
The table contains all shaped level points. Points added via mouse click into the diagram will show
up in the table. You can also use the table to enter new points manually.
3. Reference level
The reference level allows you to shift the entire shaped level curve up and down by either
entering a different reference level value or by moving the blue reference level line in the diagram.
Measurement and Device settings
OMICRON Lab
81
To Next Page
Loading...
