CP TD1 Reference Manual V 1.44
26
"Auto test points" selected = automatic measurement: Enables the output
of a series of test points, e.g., combining a series of voltage values with one fixed
frequency value creates a voltage ramp. Combining a series of frequency values
with one fixed voltage value creates a frequency ramp. Furthermore, a
combination of both is possible.
– Set a test voltage and frequency of your choice, and press A
DD TO AUTO.
The values are entered into the list boxes.
– Set a second test voltage and/or frequency, and again press A
DD TO
A
UTO. The value(s) is/are appended to the list.
– Repeat this procedure as often as you need.
Note: You cannot enter the same value twice. Double entries are rejected. If you
need identical test points for an increasing and a decreasing voltage ramp, set
values very close to each other, e.g., 2000V and 2001V.
The CP TD1 then puts out the specified list of values as follows:
1. All voltages are issued in the exact order they were entered using the first
frequency value of the list.
2. All voltages are issued once more in the exact order they were entered using
the second frequency value of the list (if any).
3. ... and so forth.
Each combination is one individual measurement, and its result is displayed in
the results table with an individual line.
To delete an entry from a list box, place the cursor on the value and press
D
ELETE VALUE. Do delete all values from both list boxes, place the cursor on
"Auto test points (V, f)" and press D
ELETE LIST.
During the measurement, the list boxes display the current output values.
To Next Page
Loading...
Need help?
General
