7
Inspection and Maintenance
This section describes the procedures for the cleaning, inspection, and maintenance
of the CK3M-series Programmable Multi-Axis Controller.
7-1
Cleaning and Inspection................................................................................ 7-2
7-1-1 Cleaning .......................................................................................................... 7-2
7-1-2 Periodic Inspections ........................................................................................ 7-2
7-2 Maintenance Procedures............................................................................... 7-4
7-2-1 Unit Replacement Precautions........................................................................ 7-4
7-2-2 Backup ............................................................................................................ 7-4
7-2-3 Unit Replacement............................................................................................ 7-4
7-1
CK3M-series Programmable Multi-Axis Controller User's Manual Hardware (O036)
7
To Next Page
Loading...
