What to do if Omron Safety Output Systems detect an over current?
If Omron Safety Output Systems detect an over current, it is likely due to trouble with the connected device. Replace the connected device to resolve this issue.
What causes an external test signal failure in Omron Safety Input Systems?
An external test signal failure in Omron Safety Input Systems can be caused by a few issues. First, the power source (positive side) may be in contact with the input signal line, or there could be a short-circuit between input signal lines. Second, there might be trouble with the connected device. To resolve this, check the wiring and replace the connected device if necessary.
What causes an overload detection error in Omron Test Output Systems?
An overload detection error in Omron Test Output Systems may be due to a ground fault or short-circuit of an output signal line, so check the wiring. Another possible cause is trouble with the connected device, in that case replace the device.
What causes 'Stuck at high' error in Omron Safety Output Systems and how to fix it?
The 'Stuck at high' error in Omron Safety Output Systems can be caused by a few things. First, check the wiring to ensure the power source (positive side) isn't in contact with the output signal line. Second, there may be trouble with the internal circuit, in that case replace the DST1. Third, ensure the I/O power supply voltage is within specifications.
What to do if Omron DST1-ID12SL-1 I/O Systems show a discrepancy error?
If your Omron I/O Systems display a discrepancy error, it could be due to several reasons. First, check the wiring for ground faults or breaks in the input signal line. Second, the connected device may have a problem, so you should replace it. Third, the discrepancy time setting may not be satisfied, so you should change the time setting.
General| Brand | Omron |
|---|---|
| Model | DST1-ID12SL-1 |
| Category | I/O Systems |
| Language | English |
To Next Page