Omron E5C series - Page 28

1 Introduction
1 - 4
E5@C Digital Temperature Controllers User’s Manual (H174)
z Communications Functions
With any E5@C model that supports communications, you can use CompoWay/F, Modbus-RTU,
*1
programless, and component communications.
*1 Modbus is a registered trademark of Schneider Electric.
*2 The E5CC-U does not support communications.
z Transfer Output
With any model that provides a transfer output, you can output the set point, process value,
manipulated variable, or other values as a 4 to 20-mA or 1 to 5-V transfer output. The E5CC-U* and
E5GC do not have a transfer output, but if the control output is a linear current output, the control
output can be used as a simple transfer output.
* The Digital Controller must be manufactured in May 2014 or later (version 2.2 or higher).
* The E5DC does not have a transfer output.
z Remote SP Input
With any model that provides a remote SP input, you can set the set point with an analog input.
* The E5CC-U, E5DC, and E5GC do not have a remote SP input.