6 Parameters
6 - 50
E5@C Digital Temperature Controllers User’s Manual (H174)
*9 When heating/cooling control is performed, the MV absolute-value upper-limit alarm functions only for
the heating operation and the MV absolute-value lower-limit alarm functions only for the cooling
operation.
*10 This value is displayed only when a remote SP input is used. It functions in both Local SP Mode and
Remote SP Mode.
• If the Digital Controller is equipped with HB/HS alarm detection, the Alarm 1 Type is not displayed for
the default settings. To use alarm 1, set an output assignment to alarm 1. (Refer to 4-6-3 Assigned
Output Functions (Assigning Control Outputs Is Not Supported for Position-proportional Models.).)
z Related Parameters
Alarm Value 1 to 4 (Operation Level): Page 6-14
Alarm Value Upper Limit 1 to 4 and Alarm Value Lower Limit 1 to 4 (Operation Level):
Page 6-15
Alarm 1 to 4 Hysteresis (Initial Setting Level): Page 6-51
Standby Sequence Reset (Advanced Function Setting Level): Page 6-63
Auxiliary Output 1 to 4 Open in Alarm (Advanced Function Setting Level): Page 6-64
Alarm 1 to 4 Latch (Advanced Function Setting Level): Page 6-69
See
See
To Next Page
