Omron E5C series - Page 300

6 Parameters
6 - 68
E5@C Digital Temperature Controllers User’s Manual (H174)
mav
Moving Average Count
• This parameter sets the number of inputs to include in the moving average. The data after
moving average processing is illustrated in the following figure.
• Use a moving average to suppress rapid changes in the input.
o-dp
MV Display A Standard Model must be used.
This parameter is used to display the manipulated variable (MV).
The manipulated variable is displayed when the MV Monitor (Heating) and MV Monitor
(Cooling) parameters are set to ON, and not displayed when these parameters are set to
OFF.
z Related Parameters
MV Monitor (Heating) (Operation Level): Page 6-16
MV Monitor (Cooling) (Operation Level): Page 6-16
ret
Automatic Display Return Time
• In the Operation Level, Adjustment Level, or Monitor/Setting Item Level, the display
automatically returns to the PV/SP if there are no key operations for the time set for this
parameter.
• The automatic display return time is disabled when the parameter is set to OFF. (In that
case, the display will not be automatically switched.)
Function
Input data
Operation result
Time
Setting
*The default is 8 for models other than the E5@C-@-0@.
Setting range Unit Default
OFF, 2, 4, 8, 16, 32 Times OFF*
Function
Setting
Setting range Default
on: Displayed, off: Not displayed off
See
See
Function
Setting
Setting range Unit Default
OFF, 1 to 99 Seconds off