Omron NX102-12 Series

4-2-4
Checking the Current IP Address
The current IP address can be confirmed in the Controller Status Pane of the Sysmac Studio, whether
it is manually set or obtained from the BOOTP server
.
Display when using the NJ-series CPU Units and NX1P2 CPU Units
• Basic Controller Status Pane
• Controller Status Pane with Details
Display when using the NX701 CPU Unit and NX102 CPU Unit
• Basic Controller Status Pane • Controller Status Pane with Details
Additional Information
• If you obtain the IP address from the BOOTP server, you can check the obtained IP address
by synchronizing and uploading the controller settings from the Sysmac Studio.
• If the IP address of the built-in EtherNet/IP port is not registered due to the following reasons,
the IP address field shows "0.0.0.0".
• The IP address was not obtained from the BOOTP server.
• The built-in EtherNet/IP port on the NX701 CPU Unit and NX102 CPU Unit is set to disa-
ble. Refer to 5-1 TCP/IP Settings Display on page 5-2 for details on the setting the IP
address of the built-in EtherNet/IP port.
4 Determining IP Addresses
4-11
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
4-2 Built-in EtherNet/IP Port IP Address Settings
4
4-2-4 Checking the Current IP Address