Omron NX102-12 Series User Manual

Versions
Hardware revisions and unit versions are used to manage the hardware and software in NJ/NX-series
Units and EtherCAT slaves. The hardware revision or unit version is updated each time there is a
change in hardware or software specifications. Even when two Units or EtherCAT slaves have the
same model number, they will have functional or performance differences if they have different hard-
ware revisions or unit versions.
Checking Versions
You can check versions on the ID information indications or with the Sysmac Studio.
Checking Unit Versions on ID Information Indications
The unit version is given on the ID information indication on the side of the product.

For NX701
The ID information on an NX-series NX701-££££ CPU Unit is shown below
.
ID information indication
Lot number Serial number Unit version
MAC address Hardware revision
LOT No. DDMYY£ xxxx
Ver.1.££
PORT1 : ££££££££££££ HW Rev. £
PORT2 : ££££££££££££
Note The hardware revision is not displayed for the Unit whose hardware revision is blank.

For NX102
The ID information on an NX-series NX102-££££
CPU Unit is shown below.
Versions
22
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)

Omron NX102-12 Series Specifications

General

Brand	Omron
Model	NX102-12 Series
Category	Controller
Language	English