CIP
status
Meaning
Add
status
Cause
11 REPLY_DATA_TOO_LARGE --- The response exceeds the maximum re-
sponse length.
13 NOT_ENOUGH_DATA --- The data length was too short for the
specified service.
15 TOO_MUCH_DATA --- The data length was too long for the
specified service.
1F VENDOR_SPECIFIC_ERROR 0102,2104 An attempt was made to read an I/O var-
iable that cannot be read.
0104,1103 The specified address and size exceed a
segment boundary
.
8001 An internal error occurred.
8007 An inaccessible variable was specified.
8031 An internal error occurred. (A memory al-
location error occurred.)
20 INVALID_PARAMETER 8009 A segment type error occurred.
800F There is an inconsistency in data length
information in the request data
8017 More than one element was specified for
a variable that does not have elements.
8018 Zero elements or data that exceeded the
range of the array was specified for an
array
.
8023 An internal error occurred. (An illegal
command format was used.)
8024 An internal error occurred. (An illegal
command length was used.)
8025 An internal error occurred. (An illegal pa-
rameter was used.)
8027 An internal error occurred. (A parameter
error occurred.)
8028
• An attempt was made to write an out-
of-range value for a variable for which
a subrange is specified.
• An attempt was made to write an un-
defined value to an enumeration varia-
ble.
8-6-2
Write Service for Variables
Specify service code 4D hex to write the value of the variable that is specified by the request path.
8 CIP Message Communications
8-84
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
To Next Page
Loading...
