123
List of Operations Appendix B
Test Mode
1. The "TST" display does not appear in protection level 2.
2. The "INI" display does not appear in protection level 1 or 2.
o
n
r
u
n
s
e
t
t
s
t
p
r
t
i
n
i
1 2 3 4
o
f
f
1 2 3 4
o
n
1 2 3 4
o
f
f
1 2 3 4
o
n
1 2 3 4
o
f
f
1 2 3 4
+
o
n
1 2 3 4
o
f
f
1 2 3 4
o
n
1 2 3 4
o
f
f
1 2 3 4
5 6
5 6
5 6
5 6
5 6
5 6
5 6
5 6
5 6
5 6
Restart after Power OFF in Test Mode
Test Mode
Connect/disconnect branch output 1.
Connect/disconnect branch output 2.
Disconnect all branch outputs.
Maximum branch output number
Connect all branch outputs.
(Press for 3 s.)
Mode Selection Menu
Select Run Mode.
Select Setting
Mode.
Select Test Mode.
(See note 1.)
Protection level
Initialize parameters.
(See note 2.)
Note
The ON/OFF display and the branch output number will flash in Test
Mode.
• When "ON" is flashing, the S8AS is waiting to connect the output.
Press the Key to connect the output.
When "OFF" is flashing, the S8AS is waiting to disconnect the output.
Press the Key to disconnect the output.
• Connecting/Disconnecting All Branch Outputs
Press the Key when "ON" is flashing to connect all outputs and
check the operation of the startup sequence.
Press the Key when "OFF" is flashing to disconnect all outputs and
check the operation of the shutdown sequence.
To Next Page
Loading...
Need help?
General
