Omron SYSDRIVE 3G3EV SERIES

")
Constant
no.
SettingSetting rangeDescriptionIndi-
cators
n50 Over-torque
detection
0: Inverter does not monitor
over-torque.
d
e
t
e
c
t
o
function
selection
1: Inverter monitors over-torque only
when speed is matched. It continues
operation even when over-torque is
detected.
2: Inverter monitors over-torque only
when speed is matched. It
discontinues operation when
over-torque is detected.
3: Inverter always monitors over-torque
during operation. It continues
operation even when over-torque is
detected.
4: Inverter always monitors over-torque
during operation. It discontinues
operation when over-torque is
detected.
n51 Over-torque
detection level
30 to 200 (%) [160]
n52 Over-torque
detection time
0.1 to 10.0 (seconds) [0.1]
n53 Frequency
detection level
0.0 to 400 (Hz) [0.0]
n67 Unit no. 0 to 15 (Unit no. setting) [0]
Note Values in shaded sections or values in brackets represent factory settings.
  Chapter 7