44
Attribute: Encompasses four parameters concerning the way a le is processed.
Repeat times: Sets how many times the process is repeated.
Repeat delay: Sets the interval between two repeated processing.
Once the repeat times and delay is set and saved, the change applies to all the les that are currently on the
system’s worklist unless it suers a power breakout or being turned o.
Feed times: Sets how many continuous times the system feeds the laserable workpiece during one engraving task.
Feed Length: Controls the length of the workpiece that is conveyed onto the workbed.
Feed Delay: Sets the interval between two consecutive workpiece feeds.
Array: Encompasses all the array information of the le under the lename that you have tapped in the main menu,
including direction, size, number, interval1, interval2, dislocation, and mirror.
To Next Page
Loading...
