Crocus CNV Alarm attributes
Reference manual 127
9.2.2 General alarm attributes
The general alarm attributes totalAlarmLevel and alarmInfo are explained below.
crocusIfConv<2m/Nx64><Tt/Cv>/totalAlarmLevel
This attribute is only present in the top object of the containment tree of the Crocus CNV,
crocusIfConv<2m/Nx64><Tt/Cv>.
It displays the priority level of an unmasked, active alarm. When several alarms are generated at the
same time, the highest priority level is shown. If the alarm levels are set in a structured manner, one look
at the totalAlarmLevel attribute enables the operator to make a quick estimation of the problem.
The value of the totalAlarmLevel attribute is also communicated to the central management system (e.g. HP
OpenView
) where it determines the colour of the icon. This colour is an indication of the severity of the
alarm.
crocusIfConv<2m/Nx64><Tt/Cv>/…/alarmInfo
The alarmInfo contains the actual alarm information of the corresponding object. The alarmInfo attributes
are:
Attribute Displays for the corresponding object …
discriminator
the total alarm count since the last cold boot.
currentAlarms
the current alarms.
previousAlarms
the second most recent alarms. However, only in case the most recently
generated alarm was an unmasked alarm (refer to Section 9.2.1 Configuration
alarm attributes, the alarmMask attribute).
alarmMask the alarmMask as configured in the Configuration group. Refer to Chapter 6 -
Configuration attributes.
alarmLevel the alarmLevel as configured in the Configuration group. Refer to Chapter 6 -
Configuration attributes.
To Next Page
Loading...