OneAccess Crocus CNV - Interface configuration attributes

Crocus CNV Configuration attributes
Reference manual 79
crocusIfConv<2m/Nx64><Tt/Cv>/security default: <empty>
In order to avoid unauthorised access to the network and the Crocus CNV, you can create a list of
passwords with associated access levels. The security attribute contains the following elements:
Element Description Default value
password
The password is a string of maximum 10 characters.
<empty>
accessRights
This attribute represents the access levels assigned to a
password. It is a bit string whereof each bit corresponds to an
access level. The table below describes the different access
levels.
111
Element Description
ReadAccess
A password that includes this access
level allows you to read all attributes,
except security attributes.
on
WriteAccess
A password that includes this access
level allows you to change all attributes,
except security attributes. Moreover, the
security attributes cannot be read.
on
SecurityAccess
A password that includes this access
level allows you to read and change
security attributes. The Crocus CNV has
the following security attributes:
• crocusIfConv<2m/Nx64><Tt/Cv>/security
on
If no passwords are created, everybody has complete access.
If you define at least one password, it is impossible to access the Crocus CNV with TMA if you do not
enter the correct password.
If you create a list of passwords, you should create at least one with write and security access. If not, you
will be unable to make configuration and password changes after activation of the new configuration.