Configuration attributes Crocus CNV
80 Reference manual
Correcting the security table
If you forgot your password or you forgot to create one with write and security access, then you can set
the Load Default Configuration DIP switch. As a result, the Crocus CNV reboots in its default
configuration. You can then retrieve the erroneous configuration and correct it.
To correct the security table, proceed as follows:
Step Action
1 Remove the Crocus CNV from the CN4 card nest as described in Section 3.2.5 -
Changing DIP switch and strap settings of the Card Version.
2 Set DIP switch bank DS5 position 1 (for converter A) and / or 2 (for converter B) to off.
To locate this DIP switch bank, refer to Section 3.2.1 - Location of the DIP switches on
the Card Version.
3 Re-insert the Crocus CNV in the CN4 card nest.
⇒ The Crocus CNV reboots and loads the default configuration.
4 Retrieve the erroneous configuration:
1. Open a TMA session on the Crocus CNV (refer to Section 4.2 - Connecting to a
Crocus CNV with TMA).
2. Execute the Load saved configuration command.
3. Correct the error in the security table.
4. Execute the Activate Configuration command.
5 Reset DIP switch bank DS5 position 1 (for converter A) and / or 2 (for converter B) to on.
6 Re-insert the Crocus CNV in the CN4 card nest as described in Section 3.2.5 -
Changing DIP switch and strap settings of the Card Version.
⇒ The Crocus CNV reboots in normal operation mode.
To Next Page
Loading...