WorkBee CNC Drag Chains Assembly 9
2.1.3 Y-Axis Moving End Assembly
A. Insert 2 x M5-Nyloc-Nuts into the insets on the Y-Drag-Chain-Moving-End-Mount.
They are a snug fit, so may require a light tap with a hammer.
B. Attach a Drag-Chain-Moving-End to the Y-Drag-Chain-Moving-End-Mount in the orien-
tation shown above using 3 x M5-Low-Profile-15mm bolts and 3 x M5-Nyloc-Nuts.
To Next Page
Loading...
