ooznest WorkBee CNC - Default Chapter; Table of Contents

WorkBee CNC 1
Table of Contents
1.0 Getting Started 3
1.1 About The Kit 4
1.2 Check Product Contents 4
1.3 Tools Required 4
1.4 Notes on Assembly 4
2.0 Drag Chains Assembly 6
2.1 Y-Axis 7
2.1.1 Y-Axis Fixed End Assembly ........................................................... 7
2.1.2 Y-Axis Fixed End Mounting............................................................ 8
2.1.3 Y-Axis Moving End Assembly......................................................... 9
2.1.4 Y-Axis Moving End Mounting ....................................................... 10
2.1.5 Y-Drag-Chain............................................................................ 11
2.2 X-Axis 12
2.2.1 X-Axis Fixed End Mounting ......................................................... 12
2.2.2 X-Axis Moving End Assembly ...................................................... 13
2.2.3 X-Axis Moving End Mounting....................................................... 14
2.2.4 X-Drag-Chain ........................................................................... 15
3.0 Power Supply Assembly 16
3.1 Output 17
3.1.1 Securing XT60-Male Outputs ...................................................... 17
3.1.2 Inserting LED-Volt-Meter............................................................ 18
3.2 Input 19
3.2.1 IEC-Inlet Wires ......................................................................... 19
3.2.2 Attaching IEC-Inlet.................................................................... 20
3.3 Connecting PSU-Cover 21
3.3.1 Connecting Wires ...................................................................... 21
3.3.2 Attaching PSU-Cover ................................................................. 23
3.3.3 Testing .................................................................................... 24
4.0 Limit Switches & Wire Routing 25
4.1 Limit Switches 26
4.1.2 Z-Axis Limit Switch.................................................................... 28
4.2 Wire Routing 29
4.2.2 Screw Driven - Gantry Wire Routing ............................................ 30
4.2.3 Belt Driven - Gantry Wire Routing ............................................... 31
4.2.4 Screw Driven - Y-Axis Wire Routing - Part 1 .................................. 32
4.2.5 Screw Driven - Y-Axis Wire Routing - Part 2 .................................. 33
4.2.6 Belt Driven - Y-Axis Wire Routing ................................................ 34
5.0 CNC xPro Assembly 35
5.0.1 Terminal-Block Attachment......................................................... 36
5.0.2 Fan Mount Assembly.................................................................. 37
5.0.3 Attaching The CNC-xPro ............................................................. 38
5.0.4 Fans Wiring .............................................................................. 39
5.0.5 Mounting the CNC-xPro Assembly................................................ 40
6.0 Wiring & Commissioning 42
6.1 CNC-xPro Wiring 43
6.2 Software & Machine Settings 44
6.2.1 Installing Universal G-Code Sender (UGS) .................................... 44
6.2.2 Configuring The Firmware .......................................................... 45