ooznest WorkBee CNC Assembly Instructions

WorkBee CNC Appendix C 66
Connect the CNC xPro via USB and make sure Universal G-Code sender is closed. Open
the Arduino IDE. In the Arduino IDE set Tools > Board to ‘Arduino/Genuino Uno’. Set
Tools > Port to the port the CNC xPro is connected to. Set Tools > Programmer to
‘AVRISP mkII’
Open Files > Examples > EEPROM > eeprom_clear and then click the upload button
(Second button in from the left, is a arrow pointing to the right) if this gives an error
please contact us. If you get the ‘Done uploading message’ follow these steps to upload
GRBL: https://github.com/grbl/grbl/wiki/Compiling-Grbl

ooznest WorkBee CNC Specifications

General

Brand	ooznest
Model	WorkBee CNC
Category	Power Tool
Language	English