Opticum HD X403P - 3 Operating Notes; Automatic Power down; Working with External USB Drive (Only for Receivers with USB Connector)

U
U
s
s
e
e
r
r
m
m
a
a
n
n
u
u
a
a
l
l
4
3. Operating notes
NOTE!
3.1. Automatic Power Down
In accordance with actual European Union requirements, Your receiver is equipped with function
"Automatic Power Off". It works by switching the receiver into standby mode after a period of 3 hours
after the last active use. In practice this means that if during this time the receiver will not be given any
command by using the remote control or keypad on the front panel, the receiver turns off. Turning off the
receiver will be preceded (2 minutes previous) by a relevant message appears on the TV screen. Please
also note that this feature is enabled by default, but at Your own request, You can disable it using the
appropriate functions in the receiver menu.
3.2. Working with external USB drive (only for receivers with USB
connector)
•
•
During the selection and operation with USB drive (hard drive, flash memory), user should pay
attention on:
•
Drive is compliant with USB 2.0 and have the appropriate parameters of read and write speed,
•
Drive contain single partition, formatted in a supported format,
•
If necessary (especially for USB hard drives, which are characterized by a high power
consumption), drive should be supplied from an external power supply,
•
Do not disconnect during a write/read data operation,
Mismatch above recommendations may result in incorrect operation of the devices and in extreme cases
can cause damage.
Do not use very full or fragmented drive,
The manufacturer takes no responsibility for any damages directly or indirectly caused by loss of
recorded or edited data stored on an external USB drive which was connected to the receiver, and gives
no warranty for any other data on the USB drive when case of abnormal function receiver will
happened.