Oracle Quad Port 10GBase-T - Configuring Jumbo Frames; Change the MTU Permanently (Oracle Solaris)

Configuring Jumbo Frames
Jumbo frames can support up to 9706 MTU. The default value is 1500 MTU.
■
“Change the MTU Permanently (Oracle Solaris)” on page 61
■
“Change the MTU Temporarily (Oracle Solaris)” on page 62
■
“Configure Jumbo Frames (Linux)” on page 62
Related Information
■
“Understanding the Installation Process” on page 11
■
“Understanding the Adapter” on page 15
■
“Confirming Specifications and Requirements” on page 21
■
“Updating Software” on page 25
■
“Installing the Driver” on page 27
■
“Installing the Adapter” on page 37
■
“Configuring the Network” on page 47
■
“Configuring Jumbo Frames” on page 61
■
“Configuring a Link Aggregation” on page 65
■
“Configuring VLANs and VXLANs” on page 69
■
“Removing the Driver” on page 75
■
“Troubleshooting the Adapter (Oracle Solaris)” on page 83
Change the MTU Permanently (Oracle Solaris)
Take one of these actions.
■
Add this line in the /etc/driver/drv/i40e.conf file and reboot the server.
default_mtu = desired-frame-size;
where desired-frame-size value can range from 1500 to 9706.
Configuring Jumbo Frames 61