Verify the Adapter Installation (Oracle SPARC)
Caution - Do not use excessive force when installing the adapter into the PCIe slot. You might
damage the adapter's PCIe connector. If the adapter does not seat properly when you apply even
pressure, remove the adapter, and carefully reinstall it.
9.
Detach the wrist strap and close the server.
10.
Connect the RJ45 cables to the ports.
11.
Verify the installation.
Follow the instructions in the appropriate section.
“Verify the Adapter Installation (Oracle SPARC)” on page 41
“Verify the Adapter Installation (Oracle Solaris x86)” on page 43
“Verify the Adapter Installation (Linux)” on page 44
“Verify the Adapter Installation (Windows)” on page 45
Related Information
■
“Adapter Description” on page 37
■
“Cable Cautions” on page 38
■
“Verify the Adapter Installation (Oracle SPARC)” on page 41
■
“Verify the Adapter Installation (Oracle Solaris x86)” on page 43
■
“Verify the Adapter Installation (Linux)” on page 44
■
“Verify the Adapter Installation (Windows)” on page 45
Verify the Adapter Installation (Oracle SPARC)
Note - Verification is not required if the server supports DR.
1.
Power on the server.
2.
When the banner appears, press the Stop-A keys or send the break signal to
interrupt the boot process and display the OpenBoot (ok) prompt.
3.
List the network devices.
ok show-nets
Installing the Adapter 41
To Next Page
Loading...
General