Configuring a Link Aggregation
These topics describe how to configure link aggregation in the Oracle Solaris 11.3 OS. For
more instructions on link aggregations in the Oracle Solaris 11 OS, refer to “Creating a Link
Aggregation” in Managing Network Datalinks in Oracle Solaris 11.3.
■
“Configure a Link Aggregation (Oracle Solaris 11)” on page 65
■
“Display Information About a Link Aggregation (Oracle Solaris)” on page 66
■
“Delete a Link Aggregation (Oracle Solaris)” on page 67
Related Information
■
“Understanding the Installation Process” on page 11
■
“Understanding the Adapter” on page 15
■
“Confirming Specifications and Requirements” on page 21
■
“Updating Software” on page 25
■
“Installing the Driver” on page 27
■
“Installing the Adapter” on page 37
■
“Configuring the Network” on page 47
■
“Configuring Driver Parameters” on page 55
■
“Configuring Jumbo Frames” on page 61
■
“Configuring VLANs and VXLANs” on page 69
■
“Removing the Driver” on page 75
■
“Troubleshooting the Adapter (Oracle Solaris)” on page 83
Configure a Link Aggregation (Oracle Solaris 11)
The example in this procedure aggregates sample interfaces i40e0, i40e1, i40e2, and i40e3.
Arbitrary key numbers (1 and 2) are used for each aggregation.
Configuring a Link Aggregation 65
To Next Page
Loading...
General