Oracle SPARC T7-2 - Determine Which Drive Is Faulty; Remove a Drive

Assign a Static IP Address to the NET MGT Port
4.
Set the netmask for the SP.
-> set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
This example uses 255.255.255.0 to set the netmask. Your network environment subnet might
require a different netmask. Use a netmask number most appropriate to your environment.
5.
Verify that the parameters were set correctly.
This example shows parameters that have been set to convert a SP from a DHCP configuration
to a static configuration.
-> show /SP/network -display properties
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_clientid = xxx.xxx.xxx.xxx
dhcp_server_ip = xxx.xxx.xxx.xxx
ipaddress = xxx.xxx.xxx.xxx
ipdiscovery = dhcp
ipgateway = xxx.xxx.xxx.xxx
ipnetmask = 255.255.255.0
macaddress = xx:xx:xx:xx:xx:xx
managementport = MGMT
outofbandmacaddress = xx:xx:xx:xx:xx:xx
pendingipaddress = service-processor-IPaddr
pendingipdiscovery = static
pendingipgateway = gateway-IPaddr
pendingipnetmask = 255.255.255.0
pendingmanagementport = MGMT
sidebandmacaddress = xx:xx:xx:xx:xx:xx
state = enabled
->
6.
Set the changes to the SP network parameters.
-> set /SP/network commitpending=true
Set 'commitpending' to 'true'
Note - You can type the show /SP/network command again to verify that the parameters have
been updated.
7.
Set the static IP address when you configure the Oracle Solaris OS.
See “Configure the Preinstalled OS” on page 58.
Powering On the Server for the First Time 67