Secure Cables to the CMA
Secure Cables to the CMA
After connecting the server cables, secure them to the CMA if a CMA was installed.
1.
Open the cable hooks and loop straps on the CMA.
2.
Route the server cables through the CMA cable hooks and straps.
3.
Secure the cables to the CMA by closing the hooks and tightening the straps.
4.
Verify the operation of the slide rails and CMA.
See “Verify Operation of Slide Rails and CMA” on page 39.
Related Information
■
“Install the CMA” on page 35
■
“Verify Operation of Slide Rails and CMA” on page 39
■
“Rear Panel Components (Installation)” on page 13
52 SPARC T7-2 Server Installation Guide • March 2016
To Next Page
Loading...
