Stabilize the Rack
Caution - The server weighs approximately 80 lb (36.28 kg) with two processors and 76.6 lb
(32.88 kg) with one processor. Two people are required to lift and mount this 3U server into a
rack enclosure when using the procedures in this document.
Related Information
■
“Physical Specifications” on page 15
■
“Handling Precautions” on page 21
■
“Stabilize the Rack” on page 26
Stabilize the Rack
Caution - To reduce the risk of personal injury, stabilize the rack by extending all anti-tilt
devices before installing the server.
Refer to the rack documentation for detailed instructions for the following steps.
1.
Read the rack cautions and stabilize the rack.
See “Rack Cautions” on page 25.
2.
Open and remove the front and rear doors from the rack.
3.
To prevent the rack cabinet from tipping during the installation, stabilize the
cabinet using all antitilt mechanisms provided.
4.
If there are leveling feet beneath the rack to prevent it from rolling, extend these
leveling feet fully downward to the floor.
Related Information
■
Rack documentation
■
SPARC T7-2 Server Safety and Compliance Guide
26 SPARC T7-2 Server Installation Guide • March 2016
To Next Page
Loading...
Need help?
General