Oracle SPARC T7-2 Installation Guide

Assign a Static IP Address to the NET MGT Port
->
Related Information
■
Server Administration
■
“Rear Panel Components (Installation)” on page 13
■
“Cabling Requirements” on page 41
■
Oracle ILOM documentation
Assign a Static IP Address to the NET MGT Port
If you plan to connect to the SP through its NET MGT port, the SP must have a valid IP
address.
By default, the server is configured to obtain an IP address from DHCP services in your
network. If the network your server is connected to does not support DHCP for IP addressing,
perform this procedure.
Note - To configure the server to support DHCP, refer to the Oracle ILOM documentation.
1.
Set the SP to accept a static IP address.
->set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
2.
Set the IP address for the SP.
a.
To change the default IPv4 DHCP property and set property values for a
static IPv4 address, type IPv4_address.
b.
To change the default IPv6 DHCP property and set property values for a
static IPv6 address, type IPv6_address.
->set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
3.
Set the IP address for the SP gateway.
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
66 SPARC T7-2 Server Installation Guide • March 2016

Oracle SPARC T7-2 Specifications

General

Brand	Oracle
Model	SPARC T7-2
Category	Server
Language	English