38
MEXE02
Status monitor
The present status of the driver can be monitored.
z
How to view the status monitor window
Item Description
Command speed (motor shaft) Monitors the present command speed.
Command speed (gearhead shaft)
Monitors the present command speed as a value converted by the set speed
reduction ratio.
Actual Speed (Motor) Monitors the present feedback speed.
Actual Speed (Gearhead)
Monitors the present feedback speed as a value converted by the set speed
reduction ratio.
Inverter voltage Monitors the present voltage value inside the driver.
Elapsed time from BOOT Monitors the time that has elapsed since the power supply was turned on.
Load Factor
Monitors the present motor output torque as a load factor.
The load factor is a value based on the rated torque being 100%.
Driver Temperature Monitors the present driver temperature.
Selection Number Monitors the operation data number presently selected.
Rotation speed setting method Monitors the setting method of the rotation speed presently set.
Acceleration time setting method Monitors the setting method of the acceleration time presently set.
Deceleration time setting method Monitors the setting method of the deceleration time presently set.
Torque limiting value setting method Monitors the setting method of the torque limiting value presently set.
Load holding torque limiting setting method
Monitors the setting method of the load holding torque limiting presently
set.
External analog setting device (Input volt...
*
Monitors the voltage value of the external analog setting device presently
input.
Rotation speed setting value Monitors the rotation speed presently set.
Acceleration time setting value Monitors the acceleration time presently set.
Deceleration time setting value Monitors the deceleration time presently set.
Torque limiting setting value Monitors the torque limiting value presently set.
Load holding torque limiting setting value Monitors the load holding torque limiting value presently set.
PWM signal input (Duty cycle)
*
Monitors the duty cycle of the PWM signal presently input.
Odometer Monitors the integrated rotation amount inside the driver.
Tripmeter Monitors the rotation amount inside the driver.
Clear tripmeter Clears the value of the tripmeter.
Sequence history Monitors the operation data numbers of the past 16 times.
Clear sequence histories Clear sequence histories.
*
"-" is displayed if not selected in the "External setting method" parameter.
D-I/O monitor
D-I/O represents direct I/O.
In addition to the ON-OFF status of direct I/O of the driver, the setting values of external analog setting device and PWM
signal input can be monitored.
z
How to view the D-I/O monitor window
Monitored items Description
INPUT Monitors the assigned input signals and each ON-OFF status.
OUTPUT Monitors the assigned output signals and each ON-OFF status.
External analog setting device
*
Monitors the input voltage value of the external analog setting device.
PWM signal input
*
Monitors duty cycle and frequency of the PWM signal input.
*
"-" is displayed if not selected in the "External setting method" parameter.
To Next Page
Loading...
