Oriental motor BLH Series - Page 40

40
MEXE02

Waveform monitor
The motor rotation speed or the status of I/O signals can be checked in a waveform format.
Refer to the operating manual of the
MEXE02
for the procedures to operate the applicable products using the
MEXE02
.
z
CH1 to CH4 (analog CH)
The rotation speed or the detected torque (actual torque), etc. can be checked. Using the waveform monitor can check
successive changes.
Monitored items Unit Range selection
Command speed (motor shaft) r/min 100, 200, 500, 1000, 2000, 5000
Actual speed (motor shaft) r/min 100, 200, 500, 1000, 2000, 5000
Inverter voltage V 1, 2, 5, 10, 20, 50
Actual torque % 10, 20, 50, 100, 200
Selection number − 1, 2, 5, 10
z
CH5 to CH12 (digital CH)
The ON/OFF status of signals can be checked. There is no setting for range and oset in the digital CH.
Monitored items Monitored items Monitored items Monitored items Monitored items
ALM-A D-OUT0 INFO-CLR INFO-RBT MOVE
ALM-B D-OUT1 INFO-DRV INFO-SET-E REV (RUN/BRAKE)
ALM-RST D-OUT2 INFO-DRVTMP INFO-SPD SPEED-OUT
D-IN0 D-OUT3 INFO-DSLMTD INFO-SPD-DE STOP-MODE (FWD/REV)
D-IN1 EXT-ERROR INFO-IOTEST INFO-TRIP TL
D-IN2 FWD (START/STOP) INFO-LOAD INFO-TRQ-DE TLC
D-IN3 H-FREE INFO-ODO INFO-UVOLT VA
D-IN4 HMI INFO-OVOLT M0
D-IN5 INFO INFO-PCOUNT M1
DIR INFO-CFG INFO-PTIME M2
z
Time scale
The following time scales can be set.
5, 10, 20, 50, 100, 200, 500, 1000, 2000, 5000 [Unit:ms]