TO RECORD A PERFORMANCE TO DISK.
1. Insert disk into organ label side up.
2. Select desired registration
3. Press “Record” button (Right hand side of First row of buttons below screen).
4. Play the piece of music.
5. Switch off the record button screen will read SAVE TO.
SONG 001. MID
6. If the recording is satisfactory press the Enter/ Yes Button (2
nd
button 2
nd
row under screen)
The screen will read SAVING. Wait until the screen changes and the green light has gone out on the
disk drive. This may take some time.
7. To play the recording press the Play/Stop button far right second row under the screen.
8. If at step 5 you are unhappy with the recording press the Escape/No button 1
st
left 2
nd
row under the
screen and the recording will be permanently deleted.
9. Subsequent recordings will automatically save as SONG 002, SONG003 etc.
TO RESTORE THE FACTORY SOUNDS
1. Insert Setup Disk into organ (label side up).
2. Press “DISK” button. (Centre second row of buttons below screen)
Screen will read :- DIRECTORY.
3. Press > Data button to right of screen.
Screen will read :- SAVE
4. Press > Data button to right of screen.
Screen will read :- LOAD
5. Press Enter/Yes button underneath the screen. (Second button second row)
Screen will read :- Overall Presets
6. Press Enter/Yes button underneath the screen. (Second button second row)
Screen will read :- GT5000 .OVP
7. Press Enter/Yes button underneath the screen. (Second button second row)
Screen will read !!! LOADING !!! , then revert to ..LOAD...
8. Press Enter/Yes button underneath the screen. (Second button second row)
Screen will read :- Overall Presets
9. Press upward arrow scroll button (1st row second button under screen)
Screen will read :- Automatic Set Up
10. Press Enter/Yes button underneath the screen. (Second button second row)
Screen will read :- GT5000 .ASU
11. Press Enter/Yes button underneath the screen. (Second button second row)
Screen will read !!! LOADING !!! , then revert to ..LOAD...
12. Switch off disk button
To Next Page
Loading...