DISK DRIVE FUNCTIONS
PLAY MODE
To use the SMF disk drive
1- Insert a standard midi file song disk into the disk drive unit.
2- Automatically the first song contained in the disk is indicated in the Disk display.
3 - Using the SCROLL buttons select the desired song from the display
4- Press the PLAY/STOP button and the selected song will start playing
5 - To stop the song press the same PLAY/STOP button again.
DISK VOLUME
This allows you to balance the overall volume of the disk unit with the rest of the instrument.
TRACKS VOLUME
Songs are usually made up of different tracks.
Sometimes is useful to have full control of the volume of a particular track of the song to balance the
overall volume.
1 - Press PLAY button.
2 - Press TRACK SELECT
3 - The display will show:
on +0db 120
Track 1 1.1
4 - Using the SCROLL buttons select the number of the track to be altered.
5 - Moving the cursor the (<) and (>) DATA buttons under the track on/off location enables you to
mute the selected track using the (/\) and (\/) SCROLL buttons, setting the track Off (--).
6 - By moving the cursor under the db volume indicator the volume can be changed up or down by
6 values. In some disks the track is indicated with the actual name of the instrument that is
playing or with other information.
To save the changes onto separate file that will be recalled automatically every time the file is selected.
Proceed as follows:
1 - Press PLAY/STOP to stop the song.
2 - Press the RECORD button and hold it.
3 - Press the TRACK SELECT button at the same time .
4 - The display will show:
SAVE Track Set
Confirm?
5 - To confirm press the ENTER button and the display will indicate
Track Set
!!SAVING!!
While the song is running the original file or the new edited file can be played.
1 - Press the DISK button and hold it.
2 - Press TRACK SELECT. In the display ## appears to identify the edited file. If the display
does not show ## the original file is selected.
To Next Page
Loading...