TRANSPOSE SET
Manual & Song
With this setting the Transpose feature will be active on the full instrument. Using the (/\) and (\/)
DATA buttons it is possible to set
TRANSPOSE SET
Song
With this setting the Transpose feature will only transpose the Song played by the
SMF disk. Using the (/\) and (\/) buttons it is possible to set the key for the song.
TRANSPOSE SET
Manual
With this setting the Transpose feature will only transpose the notes played on the keyboard without
affecting the Song notes
- to store the new configuration, simply press the SET button to exit the function.
PITCH - FINE TUNING
In the case where semitone transposition is not sufficient, and a more accurate tuning is necessary, it is
still possible to change.
To access the PITCH function.
- press the SET button. All the programmable features of the instrument will start blinking
- press the PITCH UP and DOWN buttons at the same time on the instrument panel and their
LED’s will start blinking. The display shows:
PITCH
Set value = 0
It is possible to fine tune the Pitch values from a range of -32 / +32.
LOWER VOLUME
This feature enables you to play the your melody using the Volume pedal without affecting the volume
of all the sections played on the Accompaniment Sections including SPECIAL, LOWER
ORCHESTRA and all the Auto Accompaniments and Drum lines.
Set the Volume of the accompaniment sections at the desired level using the Volume Pedal and press
the LOWER VOLUME button.
The volume levels will be stored automatically and the pedal will affect only the sections selected on
the Melody sections.
This feature will be particularly helpful when using SMF disks for your backing or for using the lower
manual as a great when playing classical organ music. LOWER VOLUME will allow you to control
the volume of the Upper Keyboard without interfering with the disk volume
Remember to switch this button off when it is not required.
To Next Page
Loading...