4.
Enter the required information in the fields provided. (Note that the options will vary
contextually according to your Version.)
5.
The Version field provides a choice between v1, v2c, and v3 [= default]
The Community field for the SNMP Community string. [v1, v2c]
SNMP User names should be between 4 and 32 characters in length. [v3]
Destination IP Version is a choice between IPv4 and IPv6. [v1, v2c, v3]
Destination IP is destination address for the notification and password key to
be sent. The default port is 162. [v1, v2c, v3]
The UDP Port number used by SNMP Traps [default = 162]. [v1, v2c]
Engine Id must be a hexadecimal number at least 10 digits long (such as
0x123456789A). The Id originates from the MIB Browser/SNMP Manager.
[v3]
1
Auth Type provides a choice between MD5 (the default) and SHA. [v3]
The Auth Password must be between 8 and 32 characters in length. [v3]
The Priv Type field provides a choice between AES and DES. [v3]
The Priv Passphrase must be between 8 and 32 characters in length. [v3]
6.
Click the Submit button at the bottom of the window. Cancel any changes by click-
ing the X-icon in the top-right corner (any information entered will be lost).
1
Should you require the Engine IDof your unit in order to decode traps sent to an NNMI, you can use an SNMPv3 "get"
value of 1.3.6.1.6.3.10.2.1.1.0 to pollyour Engine ID.
2.8 Configuring Network Settings
CHAPTER 2 • VersaSync User Manual Rev. 7.0
95
To Next Page
Loading...
Need help?
General