6.
Refresh the browser window, and login to the Web UIagain. Re-navigate to Tools >
Upgrade/Backup, and confirm that the newly installed Option is listed in the Sys-
tem Configuration panel.
4.8 Resetting the Unit to Factory Configuration
In certain situations, it may be desired to reset all VersaSync configurations back to the fact-
ory default configuration. The GNSS location, any VersaSync configurations and the locally
stored log files can be cleared via the Web UI.
Caution: It is not possible to clear the Authentication logs and NTP logs.
Note: Restoring configurations (reloading a saved configuration), erasing
the stored GNSS location and clearing the log files are separate processes.
You may restore one without restoring the others.
If VersaSync was assigned a static IP address before cleaning the configurations, it will be
reset to DHCP after the clean has been performed. If no DHCP server is available after the
clean operation, the static IP address will need to be manually reconfigured.
4.8.1 Resetting All Configurations to their Factory Defaults
To restore the configuration files to their factory defaults:
1.
Navigate to TOOLS > SYSTEM: Upgrade/Backup.
2.
In the Actions panel, click the Restore Factory Defaults (Clean) button.
3.
VersaSync restores the configuration files to the factory settings, and then reboots
in order to read the new configuration files. Once powered back up, VersaSync will
be configured with the previously stored files.
4.8 Resetting the Unit to Factory Configuration
CHAPTER 4 • VersaSync User Manual Rev. 7.0
255
To Next Page
Loading...
Need help?
General