Note: It is not normally recommended to select more than one
NTP Server in the NTP Servers table as being Preferred. Typ-
ically, only one NTP server should be selected as Preferred.
5.
Click Submit, or press Enter.
NTP Peers: Adding, Configuring, Removing
To add, configure, or remove an NTP Peer:
1.
Navigate to MANAGEMENT > NETWORK: NTP Setup.
2.
The NTP Setup screen appears. The NTP Peers panel displays a list of recognized
NTP peers.
Note: Should the list be empty, no servers have been added yet. In
the event that added peers are not displayed, they could not be
resolved. Verify the IPaddress
To EDIT the settings of an NTP Peer, click the GEAR button next to it, and
proceed to Step3 below.
To ADD a new NTP Peer, click the PLUS icon in the top right corner of the
NTP Peers panel.
To REMOVE an NTP Peer (and its associated configurations), click the X-but-
ton next to it.
3.
The NTP Peers edit window opens:
2.8 Configuring Network Settings
CHAPTER 2 • VersaSync User Manual Rev. 7.0
113
To Next Page
Loading...