Orolia VersaSync User Manual

The GPSD Setup Screen is divided into three panels:
1.
The GPSD Service panel:
allows you to toggle the service ON or OFF
lists the Service Port
the Gear Icon in the GPSD Service panel allows you to change the Service
Port information. If your GPSD setup changes and needs to be reconfigured
within your VersaSync, this is where you can reset the service port.
2.
The Actions panel provides an option to restore the default configuration.
3.
The Receiver Status panel lists the information required by the GPSD service:
Device name
Mode, Time, Position, Track/Speed/Climb, Error Statistics, and Precision Stat-
istics
All satellites in view and the PRN, Elevation, Azimuth, Signal Strength, and
Usage for each satellite.
GPSD via CLI commands
The following CLI commands are used to control the behavior of GPSD via the VersaSync
CLI:
gpsdserviceportget – Displays the GPSD service port
gpsdserviceportset – Sets the GPSD service port
There are two GPSD utility programs already incorporated into VersaSync; GPSpipe and
CGPS. Both can be used as commands within the CLI to view information currently being
sent via GPSD. Both commands use CTL + C to stop.
134
CHAPTER 2 • VersaSync User Manual Rev. 7.0
2.8 Configuring Network Settings

Orolia VersaSync Specifications

General

Brand	Orolia
Model	VersaSync
Category	Server
Language	English