Orolia VersaSync User Manual

Relocating VersaSync
The Delete Position command may need to be used if a VersaSync system is physically
moved, and it did not self-initiate a new survey automatically. Note that neglecting to
delete the old position data and discover the new position data will cause VersaSync not to
go into synchronization state.
Sanitization
The Delete Position command must also be used when sanitizing a VersaSync unit
(ensuring that no trace of position data remains on the unit).
Deleting the GNSS position
To delete the GNSS position:
1.
Disconnect the GNSS antenna from the VersaSync unit (this is required only when
sanitizing the unit).
2.
Navigate to Interfaces > References: GNSS Reference.
3.
Click on the GEAR button next to the GNSS Reference (typically, there is only one
reference, numbered "0"). The GNSS0 window will open:
Locate the Delete Position box, check it, and click Submit.
4.
VersaSync will initiate a GNSS self survey.
Note: In Mobile Receiver Mode it is NOT possible to delete the position and
start the GNSS survey. This feature is only available in Standard Mode and
in Single Satellite Mode. In Single Satellite Mode a GNSS survey may take
up to 24 hours.
3.3 Managing References
CHAPTER 3 • VersaSync User Manual Rev. 7.0
187

Orolia VersaSync Specifications

General

Brand	Orolia
Model	VersaSync
Category	Server
Language	English