Command Description
rt6add Adds an IPv6 static route
rt6del Deletes an IPv6 static route
rt6get Displays the configured IPv6 static routes
saveconf Generate archive of current configuration
savelog Generate archive of all log files
scaleget Displays configured system timescale
scaleset Used to configure the system timescale
services Displays the state of services (enabled/disabled)
servget Displays the state of individual services
servset Enable or disable specific services
slaacget Displays whether SLAAC is enabled
slaacset Used to enable or disable SLAAC
stateset Enable or disable an entry in the reference priority table. index = 0...15. state = 0
(disable), 1 (enable)
status Displays information about the oscillator disciplining
syncstate Display timing system synchronization state
sysupgrade Performs system upgrade using the update bundle provided
testevent Generates SNMP events in the enterprise MIB
tfomget Displays current estimated system time error (TFOM – Time Figure of Merit)
timeget Displays current system time (time is displayed in the configured timescale –
See
scaleget
command to retrieve the configured timescale)
timeset Used to manually set the current time (hours, minutes in seconds); time is
entered based on the configured timescale – See
scaleget
command to
retrieve the configured timescale
unrestrict Used for clearing access control restrictions to VersaSync
version Displays the installed main VersaSync and timing system software versions
yearget Displays the current year
yearset Used to set the current year
zeroize Applicable to SAASM-equipped VersaSync units only
To Next Page
Loading...
Need help?
General