Orolia VersaSync User Manual

ton to enable & configure the port, or the INFO button to view the port status.
3.
Ethernet ports are enabled by default. If the port is not already enabled, in the Edit
Ethernet Ports Settings window, click the Enable check box. The Edit Ethernet
Ports Settings window will expand to show the options needed to complete the
port setup.
Fill in the fields as required:
Enable eth0: [Checkbox]
Enable DHCPv4: [Checkbox] Check this box to enable the delivery of IP
addresses from a DHCP Server using the DHCPv4 protocol.
Static IPv4 Address: This is the default, or the unique address assigned by
the network administrator.
Table 2-5:
Default IP addresses
ETH port Default IP address
ETH0 192.168.1.1
ETH1 192.168.1.2
The default subnet is: 255.255.0.0
Netmask: This is the network subnet mask assigned by the network admin-
istrator. In the form “ xxx.xxx.xxx.xxx.” See "Subnet Mask Values" on
page342 for a list of subnet mask values.
2.8 Configuring Network Settings
CHAPTER 2 • VersaSync User Manual Rev. 7.0
65

Orolia VersaSync Specifications

General

Brand	Orolia
Model	VersaSync
Category	Server
Language	English