Operation
38
DTX-2200-3000 AC/DC
To confirm the diameter selected, simply push the
ELEC-
TRODE DIAMETER Key (T8) again
(ELECTRODE DIAME- TER LED off).
4) Press the WELDING MODE SELECTION key (T6) and go to one of the 4 options available:
L5 2T
L6 4T
L7 Bi-Level
L8 SPOT WELDING
5) Turn the ENCODER knob (E) until the DISPLAY (D) shows the CURRENT VALUE at which you wish to
weld.
6) By pushing the WELDING PARAMETERS SELECTION (T10) key a number of times it is possible to set the
various TIG WELDING PARAMETERS (see the “TIG Welding” paragraph - WELDING PARAMETERS).
7) Once the all the selections/regulations indicated above have been made, welding can begin.
8) During the welding process the DISPLAY shows the real Amps (A) at which the operator is actually welding.
14.3.6
TIG “AC and LIFT DC” welding with the SPOT WELDING
function ON
1) Start the welding machine by turning the power supply switch to position I.
To Next Page
Loading...
