Operation
60
DTX-2200-3000 AC/DC
14.3.18
Error and protection conditions
The equipment is protected against problems and if any arise the DISPLAY shows fixed or flashing (error code)
messages (depending on the type of error) that serve to inform the operator that a fault has occurred in the
equipment (see table 5).
The table provides a summary of all the error conditions that may arise on the equipment and, if possible, what
the operator must do to attempt to resolve the problem.
Automatic reset error: once the alarm condition has been resolved the equipment starts working again and the
operator can weld again!
PLEASE NOTE: If the fault persists look for the cause of the fault and contact our technical service department if
necessary.
All of this is necessary to allow our technical service department (which must be contacted each time error
messages appear on the equipment’s operator interface) to resolve problems more easily, as quickly as possible
and thanks to the user’s reports, also because, in the meantime the machine will not allow the operator to do
their work.
To Next Page
Loading...
