EasyManuals Logo

OutBack Power FLEXmax 100 User Manual

OutBack Power FLEXmax 100
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
Status and Information
900-0209-01-00 Rev A
35
MATE3s System Display
Figure 26 Display and BATTERY STATUS Indicators (MATE3s)
The MATE3s System Display and Controller is a display which allows the user to read the operating
mode, measurements, and any status messages from the FLEXmax 100 charge controller. It can also
change the charge controller’s settings when the default settings are not enough.
Battery Status Indicators
Three LED indicators provide a visual reference to indicate the condition of the battery bank.
A
G
REEN
LED means the batteries have an adequate charge at that time. It does not always mean they are
full. If the FLEXnet DC battery monitor is installed, this means the batteries are
80%
State of Charge (SOC).
A
Y
ELLOW
LED means the batteries are somewhat discharged. If the FLEXnet DC is installed, this means the
batteries are
60% and
70%.
A
R
ED
LED means the batteries are greatly discharged and may require attention. If the FLEXnet DC is
installed, this means the batteries are < 60%.
Table 5 Battery Status LED Indicators
Color 24 Vdc Unit 36 Vdc Unit 48 Vdc Unit Battery Status
G
REEN
25.0 Vdc or higher 37.5 Vdc or higher 50.0 Vdc or higher Acceptable
Y
ELLOW
23.0 to 24.9 Vdc 34.5 to 37.4 Vdc 46.0 to 49.9 Vdc Marginal
R
ED
22.9 Vdc or lower 34.4 Vdc or lower 45.9 Vdc or lower Low
NOTES:
The
B
ATTERY
LED settings cannot be changed.
Voltages higher than shown in the
G
REEN
row usually means that the batteries are charging.
Charger Indicator
The system display is equipped with several LED indicators denoting status. The CHARGER indicator
(see Figure 26) will illuminate if the charge controller is delivering more than a minimal amount of
charging power to the batteries. It will flash if the charge controller is equalizing the batteries.
NOTE: The CHARGER indicator will illuminate for any device on the HUB Communications Manager
that is charging, including OutBack inverters. If a FLEXmax 100 charge controller is accompanied by
other devices, this indicator may indicate charging by any device, not just that controller.
Battery Status Indicators
CHARGER Indicato
r
Charge Controller Soft Key

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OutBack Power FLEXmax 100 and is the answer not in the manual?

OutBack Power FLEXmax 100 Specifications

General IconGeneral
BrandOutBack Power
ModelFLEXmax 100
CategoryController
LanguageEnglish

Related product manuals