P04:
Long cone (FFD = 30cm)
When you use a 30 cm limiter cone, the exposure times in the preset
tables must be multiplied by a 2 factor to get a correct dose.
The default value is "OFF", which corresponds to the standard cone (Film
Focus Distance = 20cm).
The change from standard cone to long cone times is made by selecting
"ON".
This setting is available also in normal working or out of set-up program
modes, and it is available to the user.
P05:
Display back light
This parameter makes it possible to vary the display back light, in order
to compensate any differences in environmental light. Values are
changed by "Increase" and "Decrease" keys.
P06:
Dose Correction Factor
This parameter is used only during factory test.
NOTE:
Do not modify factory configuration.
P07:
Language
Using "Increase" and "Decrease" keys, select the desired language
between: English, Italian, French, Spanish, German, Portuguese,
Russian, Dutch, Arabic, Turkish, Chinese (traditional), Chinese
(simplified), Symbols only (visualize only the tooth symbol).
To Next Page
Loading...