Contents
3
Chapter Page Chapter Page
1 Introduction 4
2 Getting Started 5
2.1 Description of Keypad Functions 5
2.2 Description of LCD Annunciators 5
2.3 Inserting & removing the
rubber armour/stand 6
2.4 Inserting New Batteries 6
2.5 Battery Replacement 7
2.6 Connecting the Electrode 7
2.7 Electrode Information 7
2.8 Switching the Meter On 8
2.9 Changing Mode 8
3 Calibration 9
3.1 General Information 9
3.2 Temperature Calibration 10
3.3 % Saturation Calibration 11
3.3.1 100% Calibration 11
3.3.2 0% Calibration 12
3.4 mg/L or ppm Calibration 13
4 Measurement 14
4.1 Temperature Compensation 14
4.2 Taking Measurements 15
4.3 Pressure & Salinity
Compensated Measurements 15
4.4 Holding a Reading 16
5 Setup 17
5.1 Configuration Menu (COF.1) 21
5.2 Automatic Temperature
Compensation (A.ATC) 21
5.3 Selection of mg/L or ppm (b.DO) 21
5.4 Calibration Data (CAL.2) 22
5.5 Electrode Data (ELE.3) 22
5.6 Automatic Shut Off (AtO.4) 24
5.7 Reset to Factory Default (rSt.5) 24
5.8 % Saturation Offset
Adjustment (OFS.6) 25
5.9 Pressure & Salinity Adjustment 26
6 Probe Maintenance 28
6.1 Cap and Electrolyte Replacement 28
6.2 Electrolyte Solution 29
7 Troubleshooting 30
8 Error Messages 31
9 Factory Default Settings 32
10 Specifications 33
11 Replacements and Accessories 34
12 Dissolved Oxygen Theory 35
Measurement Units 36
What is being measured? 36
Air Calibration 36
Applications 37
13 Warranty 38
To Next Page
Loading...
