Panasonic AG-CPD20P - System and Recording Setup; Recording Timing Settings; File Naming and Trigger Settings

22
23
Setup
(continued)
Setting Item Factory Default Value Description
3
Rec Continue Time CONTINUE
Continuous recording time (minutes)
Setting : CONTINUE, 1 min, 2 min, 5 min, 10 min, 15 min, 20 min,
30 min, 60 min, 90 min
PreRec Time
(Video)
30 s
Video Prerecord time (seconds)
*
1
Setting : 0 s, 10 s, 20 s, 30 s, 60 s, 90 s
PreRec Time
(Audio)
0 s
Audio Prerecord time (seconds)
*
1
Setting : 0 s, 3 s, 10 s, 20 s, 30 s, 60 s, 90 s
PostRec Time
(Video)
0 s
Video Postrecord time (seconds)
*
1
Setting : 0 s, 10 s, 20 s, 30 s, 60 s, 90 s
PostRec Time
(Audio)
0 s
Audio Postrecord time (seconds)
*
1
Setting : 0 s, 3 s, 10 s, 20 s, 30 s, 60 s, 90 s
Rule of
Filename
WT
Recording le naming method
Setting : WT(World time)
LT(Local time)
Init Audio2 Rec
ON
Initial on/off setting for Audio2 input (upon power on)
Setting : ON, LAST
*
1
, OFF
Init Overlay OSD OFF
Initial OSD (on-screen display) overlay setting
Setting : OFF, AUTO, SIMPLE, DETAILS, LAST
*
2
GPO1 Signal OFF GPO1 output signal setting
*
3
Setting: OFF, REC, ERROR, REC+ERROR
GPO2 Signal
OFF GPO2 output signal setting
*
3
Setting: OFF, REC, ERROR, REC+ERROR
GPO3 Signal
OFF GP 3 output signal setting
*
3
Setting: OFF, REC
Init Audio Out
(Play)
ON Initial audio output selection (upon power on)
Setting : ON, LAST
*
2
, OFF
Play Mode SINGLE Select playback mode (relay playback setup)
Setting : SINGLE, RELAY
Skip Target
Skip position
Trigger/Marker YES
Select a trigger or marker location
Setting : YES, NO
Head of File YES
Select the starting point of the le
Setting : YES, NO
*
1 If “Loop Rec” is set to ON, pre-recording and post-
recording do not function.
Playback with the remote control panel is not available
at present. Upgrading is scheduled for the future.
For playback, it is recommended to use the Front-End
application or Back-End Client application.
*
2 Applies the setting in effect when power was last turned
off. Unless power is turned off properly, the operating
state may not be saved correctly.
*
3 The functions of GPO1, GPO2, and GPO3 can be
changed with settings, but GPO4 always outputs the
power status of the recorder, and has no setting.
(Continued on the next page)