Copying from a video cassette recorder
DV automatic recording (DV Auto Rec)
HDD
RAM
-R
-RW(V)
+R
+RW
HDD
RAM
When the “DV Auto Rec” function is used, programmes
are recorded as a title while at the same time chapters are created
at each break in the images and the playlist is created automatically.
Preparation
1 Turn off the main unit and DV equipment, then connect the
equipment with the unit’s DV input terminal (➡ 28).
2 Turn on the main unit.
y When the output signal from the external equipment is NTSC,
change the “TV System” to “NTSC” in the Setup menu (➡ 75).
1 Turn on the DV equipment, and pause
play at the point you want recording
to start.
The following screen appears.
DV Auto Rec
DV unit is connected.
Record from the DV unit?
Rec to HDD CancelRec to DVD
y When the screen is not displayed
After performing step 1
1 Press [DRIVE SELECT] to select the HDD or DVD drive.
2 Press [FUNCTION MENU].
3 Press [
e
,
r
] to select “To Others” and press [OK].
4 Press [
e
,
r
] to select “DV Auto Rec” and press [OK].
➡ Go to step 3 (➡ below).
2 Press [
w
,
q
] to select “Rec to HDD” or
“Rec to DVD” and press [OK].
3 Press [REC MODE] to select the
recording mode.
4 Press [
w
,
q
] to select “Rec” and press
[OK].
Recording starts.
When recording fi nishes
The confi rmation screen appears. Press [OK] to fi nish DV automatic
recording.
To stop recording
Press [
g
].
Note
y Only one piece of DV equipment (e.g., digital video camcorder)
can be connected to the unit via the DV input terminal.
y It is not possible to operate the unit from the connected DV
equipment.
y The DV input on this unit is for use with DV equipment only. (It
cannot be connected to a computer, etc.)
y The DV equipment name may not be shown correctly.
y Depending on the DV equipment, the images or audio may not be
input properly.
y The date and time information on the tape of the DV equipment
will not be recorded.
y You cannot record and play simultaneously.
If the DV automatic recording function does not work properly,
check the connections and DV equipment settings, and turn the
unit off and back on.
If that does not work, follow the instructions for manual
recording (➡ 28).
To Next Page
Loading...
Need help?
General
