EasyManua.ls Logo

Panasonic DP-C266

Panasonic DP-C266
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
217
Chapter 9 Solving Problems
456 Unit received a confidential
document or was requested to
be polled of a confidential
document under any of following
conditions.
1.Not enough space in
memory to receive the
confidential document.
2.Confidential Mailbox is full.
3.While printing received
document.
Unit was requested to relay a
document.
Print a confidential document.
Wait until the unit finishes printing.
Printing a
Received
Confidential
Document (See
page 72)
459 Communication error occurred. Check with the other party.
494 Communication error occurred
while receiving.
Check with the other party.
495 Telephone line disconnected. Check with the other party.
501/502/503/
504
Communication error occurred
using the internal V.34 modem.
Check with the other party.
505 Received the polling request
when documents have not been
stored for being polled.
Check with the other party.
540/541/542/
543
Communication error occurred
while transmitting.
Reload the document and send again.
Check with the other party.
550 Telephone line disconnected. Check with the other party.
554/555 Communication error occurred
while receiving.
Check with the other party.
580 Sub-address transmission to a
unit that has no Sub-address
function.
Check the remote station.
581 Sub-address Password
transmission to a unit that has
no Password Sub-address
function.
Check the remote station.
623 No document is loaded in the
ADF.
Resend the documents.
630 Redial was not successful due to
a busy line.
Reload the document and send again.
634 Redial was not successful due to
no response from the called
station or wrong number dialed.
If a dial tone is not detected, the
machine does not transmit.
Note: If busy tone was not
detected, the machine will
only redial once.
Check the telephone number, and send again.
Change the setting of the Function Parameter
68 Dial Tone Check” (Fax/Email Settings >
Fax Parameters) to “Off”.
Operating
Instructions (For
Function
Parameters)
Info. Code Problem Action Refer to
Continued on the next page...

Table of Contents

Related product manuals