81
Chapter 3 Convenient Fax Features
Password Transmission
To utilize the Password-protected Transmission feature, follow the steps below.
z You must set the password (4 digits) in the Function Parameter “43 Password-Transmit” (Fax/Email Settings
> Fax Parameters) in advance.
1
Place original(s).
z Refer to Placing Originals (see page 14).
2
Press the Fax key.
3
Select “More Menus”.
4
Select “Select Mode”.
5
Select “Password XMT”.
6
Select “On”, and then select “OK”.
7
Set “Quality Adj.” as required.
z Refer to Setting Original Quality (see page
34).
8
Select a destination.
z Refer to Entering a Destination (see page
20).
z Select an address, except the address
registered for Relayed transmission.
9
Press the Start key.
Password-protected transmission starts.
z The transmission fails if the password of
both units does not match.
Select to perform
Password-protected
transmission.
Select not to perform
Password-protected
transmission.
To Next Page
Loading...
