z ST2110 RX
Make SMPTE ST2110 reception settings.
The setting is confirmed with the [Set] button.
<NOTE>
• This menu is not displayed when [ST2110] is [Off].
Return video
<NOTE>
• Return video cannot be input when [ST2110] is [Off] and [Basic
Config] – [Format] is other than [1080/59.94p] or [1080/50p].
Format
Display the input format for [Return video].
Destination Address
Enter the multicast address of the stream to be received as
[Main video].
The setting range of the IP adresses can be set.
First octet 224 to 239
Second octet 0 to 255
Third octet 0 to 255
Fourth octet 0 to 255
0.0.0.0 and 224.0.0.0 to 224.0.1.255 cannot be set as the IP address.
Factory settings: 239.3.0.1
Source Address
Enter the IP address of the device that is the transmission source of
the stream to be received as [Main video].
The setting range of the IP adresses can be set.
First octet 0 to 223
Second octet 0 to 255
Third octet 0 to 255
Fourth octet 0 to 255
An IP address with a first octet that is 127 cannot be set.
Factory settings: 0.0.0.0
<NOTE>
• Filtering by the transmission source address is not performed if
0.0.0.0 is set.
• If the network switch you are using does not support IGMPv3,
filtering by the transmission source address is not possible.
Destination Port [1024 to 65535]
Enter the port number of the stream to be received as [Main video].
10670 cannot be set as a port number.
Factory settings: 49331
z PTP
Make PTP settings.
Domain
Enter the PTP domain number.
Factory settings: 127
<NOTE>
• The domain number needs to be set in conjunction with the grand
master. Consult the network administrator regarding settings for the
grand master.
• This can only be set when [Sync signal] is [PTP].
Sync signal
The screen for setting the synchronization signal for video/audio is
displayed when you click [Sync signal>>]. (→ page 115)
138
Web screen configurations (continued)
To Next Page
Loading...
